Difference between revisions of "Construction"
(→Misc.) |
|||
Line 273: | Line 273: | ||
====Fixing Disposal Pipes==== | ====Fixing Disposal Pipes==== | ||
Destroyed pipes can be replaced with new ones created in a special manufacturer. Two can be found on the station, one in the [[Warehouse]] and the other in [[Disposals]], respectively. To fix the new pipe segments in place, use the welder on the | Destroyed pipes can be replaced with new ones created in a special manufacturer. Two can be found on the station, one in the [[Warehouse]] and the other in [[Disposals]], respectively. To fix the new pipe segments in place, use the welder on the broken pipe to melt it away, then weld the new pipe in place. | ||
====Fixing Microwaves==== | ====Fixing Microwaves==== |
Revision as of 15:02, 29 August 2013
All this assumes you've figured out the game pretty well so far. You have, right?
Makin'
Weapons
Bombs
You will need:
a tank of heated GAS a tank of explosive mix (O2 + Plasma) a tank transfer valve a timer, proximity sensor, or remote signaling device
combine tank one with tank transfer valve combine tank two with tank transfer valve combine timer/prox/remote signaler to tank transfer valve
Rocket Launchers
You will need:
10 rods 10 metal 5 beakers of thermite
To Make:
IMPORTANT This will not work unless you're standing in the Toxins' mixing room with a hot, raging fire! combine rods with metal combine beakers with tube assembly
Stun Gloves
You will need:
Insulated Gloves Charged Power Cell Wire Coil
To Build:
Put wire on the gloves Hold the gloves in your active hand Use gloves on power cell
Note: Intent must be set to Harm in order for stun gloves to work. Only holds 1 charge at a time.
Flamethrowers
Not as deadly as you might think, but useful against the space kudzu and looks cool. Needs activating before use.
You will need:
An igniter 1 rods A screwdriver A small plasma tank A welder
To Build:
Screwdriver on Igniter Screwdriver on the Welder Rods on the Welder Igniter on the welder/rods assembly Screwdriver on the welder/rods/igniter assembly Welder/rods/igniter assembly on a small plasma tank
Walls, Doors, and Floors
Metal Walls
Regular
You will need:
2 sheets of metal
To Build:
Click metal while you're holding it Choose Construct Wall Girder Click wall with the metal in hand to add plating
Reinforced
You will need:
4 sheets of metal
To Build:
Click metal while you're holding it Choose Construct Wall Girder Choose Reinforced Sheet Pick up Reinforced Sheet and use it on wall to reinforce girders Use it again to add the plating
Glass Walls/Windows
Regular (One Direction) Window
You will need:
1 sheet of glass
To Build:
Click glass while you're holding it Choose "one direct"
Note: In order to manipulate the window, right-click it and choose "rotate". Also, you can secure/unsecure it with a screwdriver.
Regular (Full) Window
You will need:
2 sheets of glass
To Build:
Click glass while you're holding it Choose "full(2 sheets)"
Note: You may push/pull this window around, and secure/unsecure it with a screwdriver. Rotating it changes nothing.
Reinforced (One Direction) Window
You will need:
1 sheet of glass 1 rods
To Build:
Pick up Rods Use Rods on Glass Pick up Reinforced Glass Click Reinforced Glass while you're holding it Choose "one direct"
Note: May be rotated, and pushed/pulled. You secure it by using a screwdriver, then a crowbar, then a screwdriver again.
Reinforced (Full) Window
You will need:
2 sheets of glass 2 rods
To Build:
Pick up Rods Use Rods on glass Repeat to make 2 Reinforced Glass sheets Pick up both Reinforced Glass Sheets (They stack) Choose "full(2 sheets)"
Note: May be pushed/pulled, and secured by using a screwdriver, crowbar, and a screwdriver again.
Floors
Regular floors can be made in space by: - using rods first on empty space, creating a lattice - then placing a floor tile on top of it (floor tiles can be made from a sheet of metal) Use another floor tile on the plating to create a regular floor. Fire-resistant floors can be made using one floor tile, and one rods Use rods on plating to create a floor similar to the engine floor
Barricades
Barricades can be made in space by: - using rods first on empty space, creating a lattice - then using more rods on the lattice to create the barricade - and can be reinforced with even more rods
Hidden Doors
Hidden Door - Regular Wall
You will need:
3 (or 4) sheets of metal crowbar
To build:
Use 2 metal to build girders Use crowbar on girders Use 1 (if not 1, then 2) metal on girders
Hidden Door - Reinforced Wall
You will need:
4 sheets of metal crowbar
To build:
Use 2 metal to build girders Use crowbar on girders Use 2 metal on to make reinforced sheet Use reinforced sheet on girders
Misc.
Electric Chair
You will need:
1 electropack 1 helmet (Space helmets wont work) 1 sheet of metal
To Build:
Click metal while you're holding it Choose "chair" Use helmet on electropack to make shock_kit Use shock_kit on chair to make electrified chair
Note: Default Frequency/Code is: "144.9 :: 2". To change this you must click on electropack while you're holding it, and modify it from the pop-up interface. Electric chairs are remotely activated, but must be toggled on before usage (right click, and select "toggle power"). Also, the room must have power for the chair to work.
To disassemble the chair, use a wrench.
An electropack can be used by itself for more.. nefarious purposes. Try it out on certain parts of your body!
Station Bots
See Robots.
Computers
Normal computer:
You will need:
5 sheets of metal 2 sheets of glass 5 pieces of wire wrench screwdriver 1 circuit board
To Build:
have the metal in hand, click on it, choose 'Computer frame' wrench insert circuit board screwdriver wires glass screwdriver
Note: Useful for computers which are built from one board only.
Heavy computers and Computer terminals:
You will need:
5 sheets of metal 2 sheets of glass 5 pieces of wire wrench screwdriver 1 id scanner module (+ up to 2 more modules) 1 storage drive 1 computer mainboard
To Build:
have the metal in hand, click on it, choose 'Heavy computer frame' or 'Computer terminal' wrench insert computer mainboard screwdriver insert all modules (up to 3) wires insert storage drive glass screwdriver
Note: Useful for DOS run computers, built from components.
Fixing Propulsion Thrusters
You will need:
screwdriver rods space suit and oxygen internals
To fix:
use the screwdriver on the engine then add the rods (you only need one!)
Note: both thrusters need to be functional for the shuttle to move!
Fixing bombed APCs
This is for APCs that have been completely broken (They have a damaged sprite and the area is left unpowered), not APCs that have had their wires shorted.
You will need:
screwdriver wrench multitool 4 pieces of wire
To fix:
Use the screwdriver on the APC. Add the wire. Wrench the APC. Apply the mulitool. Finally, use the screwdriver on it again.
Fixing Disposal Pipes
Destroyed pipes can be replaced with new ones created in a special manufacturer. Two can be found on the station, one in the Warehouse and the other in Disposals, respectively. To fix the new pipe segments in place, use the welder on the broken pipe to melt it away, then weld the new pipe in place.
Fixing Microwaves
If the microwave is just dirty, use a spray bottle of space cleaner. A completely broken unit has to be fixed with some tools.
You will need:
screwdriver wrench
To fix:
Use the screwdriver on the microwave. Finish the job with a wrench.
Jack-o'-lantern
You will need:
Pumpkin Chainsaw or knife Flashlight
To build:
Use the chainsaw or knife on the pumpkin to carve it Use the flashlight on the carved pumpkin
Note: Click the jack-o'-lantern to light it
Rocket Shoes
You will need:
Emergency oxygen tank Any pair of normal shoes
To build:
Use emergency oxygen tank on shoes
Note: It will run out of gas after two uses. Do not expect much in the way of steering.
Shackles
You will need:
Handcuffs Orange shoes
To build:
Use handcuffs on orange shoes
Note: Will force the wearer to move at walking speed.
Armored Biosuit
You will need:
Biosuit Body Armor
To build:
Use body armor on biosuit
Ghost disguise
You will need:
Bedsheet Scissors or Wirecutters
To build:
Use scissors or wirecutters on bedsheet
Space Pod
You will need:
Pod frame kit Pod Circuitry Pod Control Interface Engine Manifold Armor (such as Light Pod Armor or Heavy Pod Armor) Wires Metal 5 sheets of Reinforced Glass Wrench Welder
To build:
Get the Pod Frame Kit. Deploy the box and you should have a jumble of metal. Wrench the mass of metal. It should look less like a pile of junk. Wrench again. This time it should look like a functional but unsecured frame of a space pod. Weld. Insert Wires Place Pod Circuitry inside. Add Metal Place Engine Manifold. Put Armor on the pod frame. Weld. Place Pod Control Interface Place 5 sheets of Reinforced Glass
Breakin'
For more, see Hacking
Note that almost everything can be destroyed with a bomb.. but we hope you don't get that desperate.
Walls, Doors, and Floors
Airlock
Screwdriver on Airlock Click Airlock (without screwdriver in hand) Have a Multitool in hand to test which wire does what Have a Wirecutter to cut or mend desired wire(s) If test light is on and bolts are down, pulse the wires to raise bolts. Crowbar opens unpowered doors with raised bolts Screwdriver the door to close it up when finished. Crowbar also opens powered doors, whose test lights are off,and the bolts up.
Door wiring is randomized per game, but all doors have the same wires. Using a multitool to pulse wires will only work if the door has power. Cutting wires can rid the door of some features (AI Control for instance) until the said wire is mended.
Ghetto Door hacking works on all doors:
Screwdriver on some random Airlock Wirecutters on Airlock Cut everything until the bolts drop, make a note of which color does this Leave Screwdriver the Airlock you want to open Wirecutters, cut every other wire except that one Crowbar the door
Firedoors
Crowbar to Open/Close Welder to seal Closed
Metal Grille
Wirecutter to destroy, welder to remove what's left OR Screwdriver to remove/re-secure
Some grilles are electrified, as such it would be wise to have Insulated Gloves on before attempting to destroy or dislodge it. Alternatively, hit it repeatedly with a shard of glass to avoid a shock.
Glass Windows
Welder to break OR Screwdriver to loosen, then push out OR Bashing object to break
Reinforced Windows
Screwdriver Crowbar Screwdriver OR Bash in with heavy object(Fire Extinguisher takes approximately five hits)
Regular Walls
Welder Screwdriver on 'Wall' to dislodge girders OR Wrench to dismantle girders
Note that the metal plates created by doing this obscure most of the 'wall', so be sure you are clicking on the right thing.
Reinforced Walls
Wirecutter Screwdriver Welder Crowbar Wrench Welder Crowbar Screwdriver Wirecutter Wrench
Note: Wait 5-8 secs for each to complete.
Hidden Doors - Regular and Reinforced Walls
To disassemble:
Screwdriver Wrench
Computers
Normal computer:
To Break:
Screwdriver Crowbar Wirecutters Screwdriver Crowbar (removes circuit board) Wrench Welder
Note: Not all computers can be dismantled.
ThinkDOS computer:
To Break:
Screwdriver Crowbar Crowbar (removes hard drive) Wirecutters Crowbar (removes all modules) Screwdriver Crowbar (removes motherboard) Wrench Welder
APC
Screwdriver Click on APC and drag the windows away from each other so you can see both at once Get wirecutters out of your toolbox/backpack/pockets and use them on the APC with the windows still open
There are four wires. Two short out the APC when cut, one cuts AI control when cut, and one does nothing when cut, but unlocks the APC when pulsed with a multitool. There's a chance you'll get shocked when cutting wires, so either have insulated gloves or do it in an isolated area where no-one will find you. South maintenance is a good choice.
Fire Alarms, Security Cameras, and Atmosphere Alarms
Wirecutter to Break, and Fix