Powering the station

From Space Station 13 Wiki
Revision as of 16:02, 5 March 2013 by Clarks (talk | contribs)
Jump to navigation Jump to search

Engineschematic.png

How It All Works

The engine has three segments: a Hot loop, filled with gas that takes heat from the furnaces, the combustion chamber, or even both. A cold loop that uses cold gas to draw heat from the hot loop. The generator which transfers heat from the hot to the cold loop and produces power.

Gas inside the pipes has two main property, pressure and temperature.

Pressure directs the gas flow, from higher to lower pressure areas. When pressure in a loop is greater after the generator than it is before, gas flow stalls, and power output drops. Too high pressure will cause pipes to burst!
Temperature will cause gas to increase or decrease in pressure. Very little gas, when heated can reach gigantic pressure. Conversely, the cold loop will most often be at a low pressure, even when packed with gas.

The engine doesn't require incredible pressure to work correctly. Pressure must flow in the right direction, higher before the engine than it is after.

Four pumps around the loop keep the gas flowing. Toggling their speed can help to regulate the power output, or fix a pressure imbalance that is blocking gas flow within a loop.

Each canister hookup has its own pump, to increase or decrease the speed of gas injection of into a loop.

To run the generator efficiently, you must prevent the pressure from rising excessively, and keep the temperature of the hot loop to a few thousand K.

Gas

Any gas can be used as a medium in both pipe loops; and each gas has a different ability to retain heat or transfer it more quickly. Generally, safer gases will yield much lower power outputs.

Experimenting with different gas in each loop will let you discover which combinations work best, and how to control the most dangerous gas.

Pressure

The engine can be efficiently run on very small quantities of gas. Filling the pipes with entire canisters of gas is not a good practice, and will most likely cause pressure issues. Injecting small quantities of gas in the loops and the combustion chamber over time, reduces waste and allows for very high power outputs.

Too high pressure inside a pipe will cause it to fracture and leak gas. A broken pipe can be repaired by welding.

Pressure imbalances that stop the correct flow of gas can be controlled by venting gas (either to a canister, or to space). Venting is more effective if the gas flow is temporarily blocked by shutting down the intake valve or reducing the pressure of the intake pump.