Space Pod
Space Pods are the station's pilotable support craft. Capable of holding one pilot and one passenger and a variety of gizmos these wonderful craft are a sure welcome addition to a certain space station. There are two types of pod and the station comes with one pod fully decked out with armor and weaponry.
How to build the damn thing is a different story. Grab your welding mask, put on some mechanic's overalls and get cracking!
Before the Pods, there was nothing
Near arrivals there is a hangar with a single fabricator capable of manufacturing the parts needed to make a single space worthy pod. However this is not your average puzzle or toy building blocks set, this is a dirty, hard and laborious process need patience and a bit of materials.
You will need to grab the following:
- 1 Mechanical Toolbox (With everything inside)
- 1 Electrical Toolbox (You will need wires)
- Lots of Metal
- Lots of Glass
- A stack of Reinforced Glass (Do not feed into the Fabricator or you will spend the rest of the round looking for replacements!)
You will need to pressurize the hangar when you open the doors. Anything more than a 1x1 hole into space will leak lots of air. The air pumps should be turned on with the pressure set to 200. Additionally there are three sets of pipes that are connected to a O2 Canister, a Plasma Canister, and a Air Canister. Use a wrench to hook up the Air Canister and use the manual valve to open the flow. Get internals and a mask as well as the air pumps and the canisters are no guarantee from suffocation.
Pieces of the Pod
Building the Pod
Now you got the pieces all memorized its time to build the damn thing. Be advised since it is a 64x64 sprite you have to stand on the South West corner of the pod sprite in order to construct it. The steps below should be followed in order.
- Get the Pod Frame Kit. Deploy the box and you should have a jumble of metal.
- Wrench the mass of metal. It should look less like a pile of junk.
- Wrench again. This time it should look like a functional but unsecured frame of a space pod.
- Weld.
- Insert Wires
- Place Pod Circuitry inside.
- Add Metal
- Place Engine Manifold.
- Put Light/Heavy Pod Armor on the pod frame.
- Weld.
- Place Pod Control Interface
- Place 5 sheets of Reinforced Glass
This will complete your Space Pod. To add extras simple use a crowbar on the pod and add any system.
Flying the Pod
Getting inside the pod is easy enough. Simply right click on it and select "Board".
When inside the pod you must turn on the engine. This will allow the pod to move in any direction. To find the on switch go to the top right hand of your game window and find the tab that lists the Space Pod's systems.
Before exiting the hangar and flying into space you must turn on the internal atmosphere system. This will ensure a steady supply of Oxygen and prevent you from suffocating. You can use your own internals if you want to conserve energy. It is generally advisable to have a space suit or emergency suit with a tank of Air or Oxygen with you at all times when flying.
An onboard computer system will assist you in flying.