User:Vortex1942/Automating the TEG

This page is under construction.
The following information may be incomplete.

Wireless Devices

Using a multitool on a WiFi capable device will tell you it's frequency

Pumps
Pumps Powered down pumps do not transfer gas, Meaning they can be used as controllable Electronic Valves, Commands The following points demon WARNING: Omitting `tag` will cause commands to be sent to ALL pumps Power on `command`: `power_on` `tag`: `(Pump Name)` Power off `command`: `power_off` `tag`: `(Pump Name)` Set target pressure NOTE: `parameter` has a max value of 5066.25kPa `tag`: `(Pump Name)` `command`: `set_target_pressure` `parameter`: `(Target Pressure)` Broadcast status `command`: `broadcast_status` Pump Status The following is transmited whenever a pump recieves are command `tag`: `(Pump Name)` `device`: `AGP` `power`: `on` or `off` `target_output`: `(Target Pressure)` `address_tag`: `pumpcontrol` Packet Examples Purge Hotloop: `tag=Hot Loop Purge Pump;command=power_on` Check All Pumps: `command=broadcast_status` Set Pressure: `tag=Hot Loop Purge Pump;command=set_target_pressure;parameter=5000`

Gas Mixers
Gas Mixers Did I hear you say "Adjustable combustion chamber temperatures?" Commands Toggle Power `command`: `toggle_pump` `parameter`: `power_on` or `power_off` `tag`: `(Mixer Name)` Set gas ratio NOTE: `parameter` value is Input 1 ratio only ie. 66 = 66:33 `command`: `set_ratio` `parameter`: `(0-100 Number)` `tag`: `(Mixer Name)` Set gas pressure NOTE: `parameter` is an uncapped value `command`: `set_ratio` `parameter`: `(Target Air Pressure)` `tag`: `(Mixer Name)` Packet Examples Set Ratio to 66:33: `tag=engine_combust_control; command=set_ratio; parameter=66` Set Pressure to 75kPa: `tag=engine_combust_control; command=set_pressure; parameter=75` Turn off mixer: `tag=engine_combust_control; command=toggle_pump; parameter=power_off`

tag: (Pump Name)

: