User:Vortex1942/Automating the TEG: Difference between revisions

Revision as of 11:10, 13 December 2023

This page is under construction.
The following information may be incomplete.

Stuff that MechComp can interact with in engineering.

Using a multitool on a WiFi capable device will tell you it's frequency

NOTE: Omitting tag will cause commands to be sent to ALL pumps
Power on
- command: power_on
- tag: (Pump Name)
Power off
- command: power_off
- tag: (Pump Name)
Set target pressure
- NOTE: parameter has a max value of 5066.25kPa
- tag: (Pump Name)
- command: set_target_pressure
- parameter: (Target Pressure)

The following is transmited whenever a pump recieves are command

tag: (Pump Name)

:

@@ Line 8: / Line 8: @@
 === Pumps ===
-sss
+==== Frequencies ====
+Using a multitool on a WiFi capable device will tell you it's frequency
+* Engineering: 122.5
+* Science: 122.9
+==== Commands ====
+* '''NOTE''': Omitting <code>tag</code> will cause commands to be sent to '''ALL''' pumps
+* Power on
+** <code>command</code>: <code>power_on</code>
+** <code>tag</code>: <code>(Pump Name)</code>
+* Power off
+** <code>command</code>: <code>power_off</code>
+** <code>tag</code>: <code>(Pump Name)</code>
+* Set target pressure
+** '''NOTE''': <code>parameter</code> has a max value of 5066.25kPa
+** <code>tag</code>: <code>(Pump Name)</code>
+** <code>command</code>: <code>set_target_pressure</code>
+** <code>parameter</code>: <code>(Target Pressure)</code>
+* Broadcast status
+** <code>command</code>: <code>broadcast_status</code>
+==== Pump Status ====
+The following is transmited whenever a pump recieves are command
+* <code>tag</code>: <code>(Pump Name)</code>
+* <code>device</code>: <code>AGP</code>
+* <code>power</code>: <code>on</code> or <code>off</code>
+* <code>target_output</code>: <code>(Target Pressure)</code>
+* <code>address_tag</code>: <code>pumpcontrol</code>
+<code>tag</code>: <code>(Pump Name)</code>
+<code></code>: <code></code>