Difference between revisions of "DWAINE Telescience"
m (relay) |
(scanning outputs) |
||
| Line 29: | Line 29: | ||
<code>teleman -p 1 scan</code> will scan the coordinate and return to you whether the coordinate you selected leads to an invalid coordinate or not. | <code>teleman -p 1 scan</code> will scan the coordinate and return to you whether the coordinate you selected leads to an invalid coordinate or not. | ||
'''Example Outputs''' | |||
* <code>]Invalid coordinates (XYZ)</code>: The coordinates inside the parentheses are invalid. | |||
* <code>]No atmosphere.</code>: The coordinate is valid but it leads to somewhere without atmosphere, likely space. | |||
* <code>]Atmosphere: O2: 21.8249, N2: 82.1031, CO2: 0, Plasma: 0, Farts: 0, Fallout: 0, 293.15 Kelvin, 101.325 kPa,</code>: Coordinate is valid and leads to somewhere with an atmosphere. | |||
=== Send === | === Send === | ||
Revision as of 15:54, 28 February 2023
| This page is under construction. The following information may be incomplete. You can help by adding missing information or formatting. |
Introduction
The DWAINE computer is powerful tool that still surrounded by a lot of mystery. This page aims to teach its user how to operate a Telescience teleport pad.
Scripting
The telesci commands are very repetitive, thus its better if you use scripts to facilitate your job. Either make your own or use existing scripts.
Basic Commands
Access to the teleman requires Super User Access. The program itself is located at /sys/srv/teleman but its easier to work with if its copied to your home directory.
Telepad ID
Every telepad connected to the mainframe has its own ID number which increases sequentially in number starting at 1. The telepad can be referenced by using -p ID. Running teleman without specifying the ID will default to 1.
Setting coordinates
Before using other commands the teleman must be first configured to a coordinate.
teleman -p 1 coords X Y Z sets the teleporter pad coordinates. This process is very repetitive, thus its better
Scanning
After the coordinates are set the telepad is ready to receive commands.
teleman -p 1 scan will scan the coordinate and return to you whether the coordinate you selected leads to an invalid coordinate or not.
Example Outputs
]Invalid coordinates (XYZ): The coordinates inside the parentheses are invalid.]No atmosphere.: The coordinate is valid but it leads to somewhere without atmosphere, likely space.]Atmosphere: O2: 21.8249, N2: 82.1031, CO2: 0, Plasma: 0, Farts: 0, Fallout: 0, 293.15 Kelvin, 101.325 kPa,: Coordinate is valid and leads to somewhere with an atmosphere.
Send
Sends the object or person on the telepad to the configured coordinate.
teleman -p 1 send
Receive
Receives the object or person on configured coordinate to the telepad.
teleman -p 1 receive
Portal
Creates a portal on the telepad linked to the configured coordinate.
teleman -p 1 portal
Relay
A bit different from the other commands, this one doesn't need to have a coordinate configured first.
The relay command attempts to receive from a coordinate X1 Y1 Z1 and send to a coordinate X2 Y2 Z2. It operates as if the user first sends the receive command then the send command.
teleman -p 1 X1 Y1 Z1 X2 Y2 Z2